Table of Contents
Advertisement
■ Turning power ON
Prior to using the transceiver for the first time, the battery
pack must be fully charged for optimum life and operation.
(p. 35)
q Rotate [VOL] to turn the power ON.
w If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
• 10-keypad can be used for password input.
• The keys in the table below can be used for password input:
• The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
0
1
NUMBER
5
6
e When the "PASSWORD" indication does not clear after
inputting 4 digits, the input code number may be incorrect.
Turn the power off and start over in this case.
DOWN
2
3
4
7
8
9
BASIC OPERATION
D Battery type selection
The battery type must be selected according to the attaching
battery type when tuning the transceiver ON.
➥ While pushing and holding [EMERGENCY] and [PTT], ro-
tate [VOL] to toggle the attaching battery type.
• After the display appears, release [EMERGENCY] and [PTT].
• "DRY BATT" is displayed for about 3 sec. then "Lo" (low power
indicator) appears when the battery case operation is selected.
• "LI-ION" is displayed for about 3 sec. when the Lithium-ion bat-
tery operation is selected.
[EMERGENCY]
[PTT]
This operation may not be available depending on the pre-set-
ting. Ask your dealer for details.
3
1
2
3
4
5
6
7
8
9
[VOL]
10
11
12
13
14
15
16
11
Advertisement
Table of Contents
