Wall Mounting - Dimplex Saletto LPP050 Operating Instructions Manual

General
The heater is designed for wall mounting on the
wall bracket supplied. It should only be operated
when in the upright position. - see Fig.1 and
Fig.2.
All models are splashproof to IPX4 standard
and may be used in bathrooms, however not in
the immediate vicinity of baths, showers, water
connections, wash basins or swimming pools.
Before connecting the heater check that the supply
voltage is the same as that stated on the heater.
NOTE - Lit cigarettes, candles and oil burners,
combined with the convection effect of electric
heaters can cause soot deposits to build up on
the surface directly above and to the sides of the
heater. This is not a fault of the heater. Extensive
burning of candles or smoking in the operating
environment of this product can produce heavy
discolouration within a few months of use.
Dimensions
Model(s) Watt
LPP050 0.5kW
LPP075 0.75kW
LPP100 1.0kW
LPP150 1.5kW

Wall Mounting

IMPORTANT - The wall bracket supplied with
the appliance must be used. The heater should
be positioned observing the minimum clearances
stated around the heater - see Fig.1 and Fig.2.
DO NOT locate the heater immediately below a
fixed socket or connection box.
1. Re move wall mounting bracket from the back
of the heater by depressing the spring latch at
the top of each bracket - see Fig.3.
2. Fix the wall bracket securely to the wall through
the two screw holes provided.
3. Pre sent the heater to the wall bracket, and
engage lower slots in the back with the
bracket.
4. Rai se the heater to upright position and push
the heater onto bracket to engage top latch.
A (mm)
746
746
877
1142
A
150
Min.
Shelf
wider
than
50mm
170 Min.
100
50 Min.
250 Min.
235
150 Min.
Fig. 1
Shelf
50mm
Fig. 2
A
LPP050 672
LPP075 672
LPP100 803
LPP150 1068
A
Fig. 3