Names And Functions Of Indications On Wireless Remote Control; Preparation And Check Before Use; Noms Et Fonctions Des Indications De La Telecommande Sans Fil; Preparation Et Verification Avant Utilisation - Toshiba MMK-AP0072H Owner's Manual

NAMES AND FUNCTIONS OF INDICATIONS ON WIRELESS
REMOTE CONTROL
Display
All indications, except for clock time indication, are indicated by pressing the START/STOP button.
1 Transmission mark 1 1
1 1
This transmission mark (,) indicates when the remote control transmits signals to the indoor unit.
2 2 Mode display 2 2 2
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Dry, : Heat,
3 Temperature display 3 3
3 3
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
setting is indicated.
4 4 4 FAN speed display 4 4
Indicates the selected fan speed. AUTO or one of five fan speed levels
(LOW , LOW +
HIGH
Indicates
5 5 TIMER and clock time display 5
5 5
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
6 6
6 6 Hi POWER display 6
Indicates when the Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop the
operation.
7 7 7 7 7
(MEMORY) display
Flashes for 3 seconds when the MEMO button is pressed during
operation.
mark is indicated when keeping the button depressed for more than
3 seconds while the mark is flashing.
Press another button to turn off the mark.
8 ECO TIMER display 8 8 8 8
Indicates when the ECO TIMER is in operation.
Each time you press the ECO button, the display changes in the sequence of 1, 3, 5 or 9h.

PREPARATION AND CHECK BEFORE USE

Loading the remote control batteries.
1 Remove the cover, and insert the 1 1 1 1
batteries.
2 2 Press the RESET button. 2 2 2
The clock display flashes.
Adjust the clock.
Place back the cover.
Batteries
• To replace the batteries, use two new batteries (AAA type).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote control.
• To avoid malfunctions by battery leakage, remove the batteries
when not using the remote control for more than one month.
EN
01(EN)_1108150401 P03-07
: Fan only)
: Fan only, no temperature
, MED , MED +
) can be indicated.
when the operating mode is
5
3 1
: Cool,
,
8 6
: Dry.
• In the illustration, all indications
• Slide off the cover while
pressing the sides.
• Battery replacement
Be careful not to reverse the
(+) position and the (–)
position.
FAN
SWING
FIX
ON
FILTER
5
05.1.17, 12:19
2 7
AUTOA
A
B
4 5
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote control.
AUTO
A
B
1
MODE AUTO
ECO
Hi-POWER
TIMER
MEMO
OFF SET CLR
2
RESET CLOCK CHECK
TOSHIBA 1075000646_EN