Parts Name; Names And Functions Of Indicators And Controls On Indoor Unit; Nom Des Pieces; Nom Et Fonction Des Indicateurs Et Commandes De L'unite Interieure - Toshiba MMK-AP0072H Owner's Manual

PARTS NAME

Indoor unit
1 Room temperature sensor 1 1
1 1
2 Front panel 2 2 2 2
3 3 Air inlet grille 3 3 3
4 Air filter 4 4
4 4
5 Air outlet 5 5 5 5
6 6
6 6 Horizontal air flow flap 6
7 7 Vertical air flow flap 7
7 7
8 8 8 Display panel 8 8
9 9
9 Infrared signal receiver 9 9
! ! Remote control (wireless) !
! !
" " " Remote controller (wired, sold separately) " "
NAMES AND FUNCTIONS OF INDICATORS AND CONTROLS
ON INDOOR UNIT
Display panel
The operating conditions are indicated below.
1. (OPERATION) lamp (green)
This lamp goes on during operation.
2. (TIMER) lamp (green)
This lamp goes on white the timer reserved.
NOTES
In case of timer setting by wired remote controller,
In case of group control,
3. (STAND BY) lamp (orange)
This lamp lights up when the power is turned on or right after heating operation starts or during defrost operation
and thermo control.
CAUTION
• When the power is turned on for the first time after installation,
systems and units. When the power is turned on the next time,
While the above lamp is on, all the commands from the remote control cannot be received. However, this is not
a malfunction or failure.
• Disagreement in operation mode
If you select AUTOMATIC OPERATION in a model with no auto-changeover (cooling/heating) control setting
or if you select HEAT in a Cool Only model,
alarm sound (pi, pi) from the air conditioner due to disagreement in operation mode. Change the operation
mode with the MODE button on the wireless remote control.This disagreement indication cannot be deleted by
the wired remote controller.
• When local prohibition is set by the central control from other equipment, no signal is received even if the
remote control button is pressed. (An alarm sound "pi" arises intermittently five times.)
TEMPORARY button
If you misplace or lose the remote control or its batteries are
exhausted, push the TEMPORARY button.
1. Open the air inlet grille to push the TEMPORARY button.
You can lift the grille up to an angle wherever it will remain fixed.
Do not lift the grille any further when it stops with a clicking sound.
2. Push the TEMPORARY button to start the air conditioner.
Push this button once again to stop it. (
EN
01(EN)_1108150401 P03-07
lamp goes on main unit only. (
see page 16.)
3
" ! 2
CODE No.
SET DATA
UNIT No.
SETTING TEST R.C. No.
UNIT
SET CL
5
3 2 1
lamp does not light.
see page 7.)
lamp lights up for setting of addresses of
lamp lights up for approximately 1 minute.
lamp lights up and and
3
05.1.17, 12:19
4 3 1
6 8 9 7
lamps blink alternately with an
TEMPORARY button
TOSHIBA 1108150401_EN