Installation Requirements - Electrolux Front load washer Installation Instructions Manual

Please read and save this guide
Thank you for choosing Electrolux, the new
premium brand in home appliances. These
Installation Instructions are part of our commitment
to customer satisfaction and product quality
throughout the life of your new appliance.
Shipping Hardware
Foam shipping support (under wash tub)
removed and stored
Shipping bolts and spacers removed from
rear of appliance and stored
Hole plugs (shipped in bag in drum)
installed in holes in backsheet
Leveling
Washer is level, side-to-side and front-to-
back
Cabinet is setting solid on all corners
Water Supply
Use only new hoses and verify rubber
sealing washers are installed
HOT supply is connected to HOT inlet and
COLD supply is connected to COLD inlet
HOT and COLD water supply turned on
No leaks present at water supply
connections or appliance inlet connections -
recheck in 24 hours
Pre-installation requirements
Tools and materials needed for installation:
OR
Optional
Adjustable
universal wrench wrench
Inlet hose (x2)

Installation Requirements

Installation Checklist
OR OR
3/8" or 10 mm Ratchet and
box wrench socket set
NOTE
Hoses are not included with washer purchase.
See "Accessories" section for various inlet hose
kits to fi t your specifi c installation.
Questions?
For toll-free telephone support in the U.S.:
1-877-4ELECTROLUX (1-877-435-3287) and in
Canada: 1-800-265-8352.
For online support and product information visit
www.electroluxappliances.com.
Drain
Stand pipe or wall drain height minimum 24"
Drain hose snapped in "U" channel
(shipped in drum)
Drain hose secured in place with cable tie
(shipped in drum)
Door Reversal
Follow detailed instructions in this guide
Test hinge and latch for function
Electrical Power
House power turned on
Washer plugged in
Final Checks
Installation Instructions and Use and Care
Guide read thoroughly
Door locks and water enters drum when
cycle starts
Registration card sent in
AND
Adjustable
pliers
AND
Carpenter's level
3