Installation Instructions - Hifonics Brutus BXi1000D Owner's Manual

REFERENCE NOTE
Before you start with the installation of the sound system, disconnect by any means the GROUND connection
wire from the battery, to avoid any risk of electric shock and short circuits.
Avoid any damage removing of the components of the vehicle like wires, cables, board computer, seat belts, gastank or the like.
Ensure that chosen location provide sufficient air circulation for the amplifier. Do not mount the device into small or sealed spaces without
air circulation near by heat dispersing parts or electrical parts of the vehicle.
Do not mount the amplifier on top of a subwooferbox or any other vibrating parts, thereby parts in the inside of the amplifier may get loosen.
The wires and cables of power supply and the audio signal must be as short as possible, to avoid any losses and interferences.
1
4 x
Mounting
bracket
Amplifier
Before mounting the brackets you should remove the
castparts on each end. Then install the 4 supplied mounting
brackets on the bottom side of the amplifier with the supplied
screws. Ensure that the angled side of the brackets are
pointed to the inner side. The pre-drilled screw holes are
located on each corner of the amplifier.
3
4 x
Drill
Marking
Put the amplifier aside and then drill the holes for the
mounting screws at the before marked locations. Please
ensure not to damage any components of the vehicle while
drilling the holes. Alternatively (depends on the material of
the surface) you can also use self-tapping screws.
INSTALLATION INSTRUCTION
MECHANICAL INSTALLATION
Castpart
Vehicle
17
2
4 x
Pen or
peening
tool
Amplifier
Mounting
bracket
Uphold the amplifier with the mounted brackets to the
chosen mounting location in the vehicle. Then mark the
four drill holes with a appropriate pen or peening tool and
lead through the designated holes of the mounting brackets.
Attend that there remains enough space for the installation
of the cables and ensure that they will not be bended and
have sufficient pull relief.
4
4 x
Mounting
screws
Mounting
Amplifier
bracket
Then uphold the amplifier to the chosen position and fix
the screws through the holes of the mounting brackets into
the drilled screwholes. Ensure that the mounted amplifier
is fixed tight and not get loosen. Then mount the before
removed castparts again to the device.
Vehicle
Vehicle