Mid-Low; Low; Aux Sends Level Control; Pan/Bal Control - Alto PM-12 DRAGONFLY User Manual

4.7.4 MID-LOW

This control gives you up to 15dB boost or cut at 500Hz.

4.7.5 LOW

12
This is the Bass control. Boost male voice or kickdrum and
bass guitar. Your system will sound much bigger than what
it is. The gain range goes from -15dB to +15dB and the center
frequency is 80 Hz.

48 AUX SENDS Level Control

These four controls are used to adjust the level of the signal sent
to AUX buses, and their adjustable range goes from -
AUX1 and AUX2 can be switched to PRE/POST-FADER via the
PRE/POST button, so, generally, they can be used for monitor
application and effects & sound processors input.
AUX3 and AUX4 are configured as POST-Faders.
In this typical compact unit, excluding sending out directly to the
external effect or processor equipment, AUX SEND 4 can also be
assigned to the internal onboard effect module.

4.9 PAN/BAL Control

Abbreviation of PANORAMA control for mono channels, for the
stereo channels, always says, BALANCE control.
When the channel signal is routed to the MAIN MIX, rotate this
control to determine the amount of channel signal sent to left/right
of main mix. Keep this control in center position, then the signal
will be positioned in the middle of stage. Turn this control fully
counterclockwise, the signal will be present only on the left of MAIN
MIX and vice-versa.
Or else, assign the channel signal to SUBGROUP, then the PAN
or BAL control has the same affection to SUB 1-2 and SUB 3-4.
4.10 SG/PEAK LED
Inside your PM-12 the audio signal is monitored in several different
stages and then sent to the SG/PEAK LED. When the LED shows
green, it indicates that there present signal on corresponding
channel; When the LED turns into red, it warns you that you are
reaching signal saturation and possible distortion, then you should
reduce the input level for avoiding distortion.
4.11 MUTE Switch
Each channel is equipped with the MUTE switch. Pressing this
switch is equal to turning the fader down, which can mute the
corresponding channel output except for the PRE AUX sends,
channel INSERT send and SOLO (in PFL mode), and the MUTE
LED will illuminate.
11
13
14
15
16
to +15dB.
11
0 0
EQ EQ
HI HI
12kHz 12kHz
-15 +15 +15 -15 +15 +15
0 0
MID HI-MID
3kHz
-15 +15 -15 +15
800
0
FREQ MID-LOW
500Hz
100Hz 100Hz 8kHz
-15 +15
0 0
LOW LOW
80Hz 80Hz
-15 +15 -15 +15
0 0
1 1
AUX AUX
- - - +15 - - - +15
0 0
2 2
POST POST
PRE PRE
- - - +15 - - - +15
0 0
3 3
DFX1 DFX1
(EXT) (EXT)
- - - +15 - - - +15
0 0
4 4
DFX2 DFX2
(INT) (INT)
- - - +15 - - - +15
PAN BAL
LEFT RIGHT LEFT RIGHT
SG/PEAK SG/PEAK
MUTE MUTE
10 10
dB dB
5 5
SUB 1-2 SUB 1-2
0 0
5 5
SUB 3-4 SUB 3-4
10 10
15 15
MAIN L-R MAIN L-R
20 20
30 30
40 40
60 60
SOLO SOLO
8 9/10
11
12
13
14
15
16