Replacing Ih82 Batteries - iHome iH82 User Manual

Installing/Replacing Batteries
1. Open the battery compartment cover located on the bottom of the main unit.
2. Insert 8 "C" batteries, checking that the + and – ends of the batteries
match the drawing inside the battery compartment. We recommend
the use of alkaline batteries for longer life.
3. Close the compartment cover.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Make sure you dispose of batteries properly (see your local regulations).
Installing/Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the
remote control stops operating or its range seems reduced,
it is time to replace the battery with a new one.
1. The battery door is located on the back end of the remote.
2. Slide the battery door open and remove old battery.
3. Insert a CR2032 battery, checking that the + and – sides of the battery
match the drawing inside the battery compartment.
4. Replace the battery door.
Note: Make sure you dispose of all batteries properly (see your local regulations).
OPERATING THE REMOTE CONTROL
The Remote Control controls basic functions on the main unit and certain iPod
main unit. For best results, aim remote control towards the main unit.
Installing/Replacing iH82 Batteries
Using The Remote Control
4
Installing Batteries
Install Remote Control Battery
® functions when the iPod ® is docked in the