General Operation - McCulloch MC1275 Owner's Manual

Using Your Multi-Use
Steam Canister

GENERAL OPERATION

NOTE: Be sure that Water Reservoir has been fi lled and that all desired accessories are
connected before following these steps.
1. For fi rst time use, remove protective plastic cover from electrical plug. Plug power cord into a
electrical outlet.
2. Switch Lighted On/Off Switch to "On" position. Steam Ready Light will immediately illuminate,
indicating that unit is heating.
3. Steam Ready Light will turn off in 2-8 minutes (depending on how much water is in Water Reser-
voir), indicating that unit is fully heated and ready to begin steaming.
4. Direct Nozzle (and any connected accessory) towards surface you desire to steam, and press
Steam Button. To sanitize surfaces, point Nozzle, press Button and hold approximately 1/2 inch
from surface for at least 5 seconds. This will insure that you have killed germs and bacteria.
CAUTION: Always be sure that Nozzle and any accessory are pointed in a safe direction
(away from yourself, other people, pets, and plants) before pressing Steam Button.
5. Keep Steam Button pressed for a continuous fl ow of steam. You may also slide the Steam Lock
Switch forward while pressing the Steam Button to lock it down. This will allow a continuous fl ow
of steam without need of holding the Button down manually.
6. Using a back-and-forth motion over the area you are steaming will further enhance the clean-
ing process. Wipe steamed areas with a clean cloth to remove loosened dirt and grime. Wip-
ing the area while it is still wet is recommended, but use caution when wiping surfaces such as metal
that may still be hot.
NOTE: During use, the Steam Ready Light may illuminate. This is normal. If you notice a
drop in steam pressure, release Steam Button until Steam Ready Light turns off again.
7. Once steaming tasks are complete, turn the unit "Off" and unplug. Follow steps under Proper
Storage procedure on Page 14 of this manual.
STEAM MOPPING
NOTE: Be sure that Water Reservoir has been fi lled and that all steam mopping accessories
are connected before following these steps.
It is recommended to sweep or vacuum hard fl oors before mopping.
1. Follow Steps 1-3 of General Operation section above.
12 | ENGLISH
Montage Du Nettoyeur Vapeur
Multi-Usages
DISQUE DE BROSSAGE
REMARQUE : Le disque de brossage se fi xe sur la buse à
vapeur et non pas sur la buse principale.
1. Positionnez le disque de brossage sur l'extrémité de la buse
à vapeur et pressez-le fermement sur la buse à vapeur autant
que possible (Voir fi gure 4). Cela permettra d'éviter les fuites
de vapeur.
2. Pour retirer le disque de brossage, serrez-le fermement et
retirez-le de la buse à vapeur.
POIGNÉE DE TRANSPORT
1. Insérez la poignée de transport dans
l'orifi ce sur le dessus de l'appareil. Alignez
la poignée de façon à ce que le support
de poignée soit orienté vers l'avant de
l'appareil (Voir fi gure 5).
2. Utilisez le tournevis fourni pour serrer la vis
à l'intérieur de la poignée jusqu'à ce qu'elle
soit bien fi xée sur l'appareil.
COMMANDE DE PIÈCES ET D'ACCESSOIRES
Vous pouvez commander les pièces et accessoires de rechange de votre nettoyeur vapeur
multi-usages (modèle MC1275) sur notre site Web :
www.steamfast.com
Vous pouvez également contacter directement le Service consommateurs :
consumerservice@steamfast.com ou 1-800-711-6617
FIGURE 4
FIGURE 5
FRANÇAIS | 41