Dirt Devil Vacuum Cleaner Owner's Manual page 7

.
-
and can be cleaned with water.
CAUTION: TO PREVENT DAMAGE TO WOOD FLOORS, FOLLOW THE MANUFACTURERS CLEANING
RECOMMENDATIONS. BEFORE USING ON SEALED WOOD FLOOR, ENSURE THAT SURFACE IS
NOT WORN, BARE OR HAS SEPARATED JOINTS. DO NOT USE IN WET VACJSCRUB MODE. DO
NOT USE IF ANY OF THESE CONDITIONS EXIST.
mately 2 capfuls) of Dirt
Devile Floor Cleaner or
Hardwood Floor Cleaner
Solution Concentrate
into solution bottle cap.
Fill remainder of Clean Water Tank
with warm water up to the max fill
line (approximately 24 02.). Replace
Water Tank into main
body of cleaner.
brushes off).
switch from
losition 1 to
losition
vacuum on,
floor for dry vacuuming. NOTE: I f NOZ-
ZLE SETTING pedal i s i n the
2 position
Step on SOLUTION ON
pedal to start the flow of
cleaning solution.
NOTE: Cleaner will can-
Pour Dirt Devil"
Hardwood Floor Cleaner Solution
Concentrate into Clean Water Tank. DO
NOT USE PINE, SOLVENT, OR WAX
ting pedal in position
1. DRY vacuum entire
hard surface area to
pick-up dry debris.
I
NOZZLE SETTING pedal in
Dosition 2 and SOLUTION ON
pedal pushed down, slowly
move cleaner forward and
backward over area to be
cleaned. Overlap strokes by
l ~ t e p on
HANDLEI
RELEASE pedal to put
into cleaning position.
This will lower the nozzle
To aid in the drying process,
step on the SOLUTION OFF
pedal to stop the flow of
solution and move the han-
dle switch from position 2 to
position 1. Continue operat-
ing in 2 - WETSCRUB &
VAC position.