Customer Service - Dirt Devil Vacuum Cleaner Owner's Manual

Vacuum cleaner
Hide thumbs Also See for Vacuum Cleaner:
Table of Contents

Advertisement

Available languages

Available languages

WARNING: TO REDUCE RISK OF PERSONAL INJURY
-
UNPLUG CLEANER BEFORE SERVICING
>leaner won't
'u n
>leaner won't
sick-up o r low
suction
Water escaping
'rom cleaner
>leaner won't
jispense solutior
Brushroll not
rotating
POSSIBLE REASON
1. Power cord not firmly
plugged into outlet.
2. Blown fuse or tripped breaker.
3. Brush clogged.
4. Needs service.
5. Thermal Protector activated
1. CleanIDirty water tank
not secured.
2. CleanIDirty water tank latch
not secured properly.
3. Dirty water tank is full.
4. Dirty water passage
clogged.
5. Filter clogged or dirty.
1. Dirty water tank is full.
2. Dirty water tank not
installed correctly.
3. SOLUTION ON pedal
engaged.
1. CleanlDirty water tank not
installed properly.
2. Clean water tank empty.
3. SOLUTION ON pedal not
engaged.
4. Handle in uprightllocked
position.
1. Brushes clogged.
2. Belt broken.
3. Incorrect handle switch
position.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replac6
fuseheset breaker.
3. Remove debris from brushroll and
push motor reset button.
4. Take to service center or call
1-800-321 -1 134.
5. Unplug cleaner. Allow to cool for 30
minutes before use
-
Pg. 3.
1 .. Secure tank
-
Pg. 8.
2. Secure latch
-
Pg. 8.
3. Empty dirty water tank - Pg. 8.
4. Clean Dirty Water Tank
-
Pg. 8.
5. Remove filter and clean
-
Pg. 9.
1. Empty dirty water tank
-
Pg. 8.
2. Insert CleanIDirty Water Tank
correctly
-
Pg. 9.
3. Step on SOLUTION OFF pedal to
turn off solution dispense
-
Pg. 5 & 7.
1.
Install CleadDitty water tank
-
Pg.
7 & 8.
2.
Fill Clean Water Tank
-
Pg.
7.
3.
Step on SOLUTION ON pedal to
turn on solution dispense
-
Pg.
9.
4. Step on handle release pedal and
lower handle (cleaner has a solution
shut off valve that stops the flow of
solution when the handle is returned
to
the uprightllocked position.
1. Unplug unit. Remove debris from brush.
roll and push reset button on handle.
2. Take to a service center or call
1-800-321-1 134.
3. Move handle switch to position 2
(vacuum on, brushes on)
-
Pg. 7.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED SERVICE REPRESENTATIVE
CUSTOMER SERVICE
(1 -800-321 -1 134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royalm Dealer. Costs
of any transportation to and from any place of repair are to be paid by the owner. The service parts used in
this unit are easily replaced and readily available from an authorized Royalm Dealer or retailer. Always identi-
fy
your cleaner by the model number and manufacturing code when requesting information or ordering
replacement parts. (The model number appears on the bottom of the cleaner.)

Advertisement

Table of Contents
loading

Table of Contents