Philips Norelco SensoTouch 1190X User Manual page 15

ENGLISH
28
Always remove appliance from canister by lifting
straight up. Do not tilt Jet Clean System.
C
Pour the Jet Clean Solution (Model HQ200)
3
into the canister up to a level between the
two lines located inside the canister.
NOTE: ONLY USE PHILIPS NORELCO JET
CLEAN SOLUTION (MODEL HQ200) WITH
THE JET CLEAN SYSTEM. ANY OTHER
SOLUTION MAY CAUSE DAMAGE TO YOUR
RAZOR.
C
Q When the cleaning solution level drops below
the minimum level, the 'cleaning chamber
empty' symbol will blink and the razor holder
will move to the starting position.
Q If you clean your razor every day, you should
clean and refill the canister approximately every
15 days.
C
4 Carefully lower the appliance back onto
the Jet Clean canister making sure the
release buttons snap back into place.
When the canister is filled with cleaning solution,
do not move appliance to prevent leakage.
Jet Cleaning the Razor
Q If the razor does not contain enough power
for one (1) shave, the Jet Clean Cleaning
System may not work properly. Charge the
razor in the Jet Clean System before using the
Jet Clean System to clean your razor.
Q If you use the razor with shaving foam, quickly
rinse under hot water before cleaning in the
Jet Clean System.
Connect the small plug to the Jet Clean
1
System. Connect the charging plug into
any 100V to 240V AC outlet. Use only the
charging plug provided.
2. Place the Jet Clean System on a flat, level
surface. Fill the canister with cleaning
solution (see 'Preparing Jet Clean System
For Use').
C
Remove protective cap from razor.
3
C
4 Place the razor head side down in the
razor holder with the display facing the
front of the Jet Clean System.
ENGLISH
29