Jeep Patriot 2013 Owner's Manual page 347

required. However, the conventional brake system will
continue to operate normally if the "Brake Warning
Light" is not on.
If the "ABS Warning Light" is on, the brake system
should be serviced as soon as possible to restore the
benefits of anti-lock brakes. If the "ABS Warning Light"
does not come on when the ignition switch is turned to
the ON position, have the bulb repaired as soon as
possible.
If both the "Brake Warning Light" and the "ABS Warning
Light" remain on, the ABS and Electronic Brake Force
Distribution (EBD) systems are not functioning. Immedi-
ate repair to the ABS is required.
When the vehicle is driven over 7 mph (11 km/h), you may
also hear a slight clicking sound as well as some related
motor noises. These noises are the system performing its
self-check cycle to ensure that the ABS working properly.
This self-check occurs each time the vehicle is started and
accelerated past 7 mph (11 km/h).
ABS is activated during braking under certain road or
stopping conditions. ABS-inducing conditions can in-
clude ice, snow, gravel, bumps, railroad tracks, loose
debris, or panic stops.
You may also experience the following when the brake
system goes into anti-lock mode:
• the ABS motor running (it may continue to run for a
short time after the stop)
• the clicking sound of solenoid valves
• brake pedal pulsations
• a slight drop or fall away of the brake pedal at the end
of the stop
These are all normal characteristics of ABS.
STARTING AND OPERATING 345
5