Touch Screen; Apply The Touch Screen Protective Film; Installation - Honeywell Thor VM2 User Manual

Vehicle mount computer microsoft windows embedded standard operating systems

Hide thumbs Also See for Thor VM2:

Table of Contents

Touch Screen

The Thor VM2 touch screen protective film is shipped in packs of 10. The protective film is flexible and treated with an anti-

glare coating on the outer surface.

The protective film is slightly larger than the Thor VM2 touch screen, however the notches on the edge of the protective film

(indicated by arrows 1 - 4 above) correspond to the display size of the Thor VM2. The protective film is not adhesive. The

corner edges are designed to fit between the Thor VM2 display and the display housing to hold the protective film in place.

A protective backing is applied to the rear surface of the protective film. A pull tab (item 5 above) is attached to the protective

backing for easy removal of the protective backing from the film.

1. Make sure the touch screen is clean and dry before installation. Please review

suitable cleaning agents.

2. Pull the release tab to separate the protective backing from the rear of the protective film. Avoid touching the rear side of

the protective film while removing the liner.

3. Place the rear side of the protective film against the Thor VM2 display, roughly centering the protective film over the

display.

4. Slide the protective film until one corner can be slid back between the touch screen and the display housing as the

protective film is re-centered on the display. It may be necessary to press the edges of the protective film against the

display to ensure the entire edge slides under the display housing. It is easiest to start with one of the bottom corners.

Cleaning the Display

for instructions on

2-15

Table of Contents