Traxxas Spirit Operating Instructions Manual page 9

STEP 32
Mount the rear shocks using
four (4) 3x12.5mm shoulder
screws.
3x12.5mm
Shoulder Screw
Spirit
Tom-Cat
STEP 35B
TOM CAT
Slide the front wheel onto the
axle followed by a 5x10mm
fiber washer. Secure with a
4mm locknut. Do not over
tighten.
STEP 33
Mount the front tires (rubber)
onto the front wheels (plas-
tic). Mount the rear tires
(rubber) onto the rear wheels
(plastic). TOM CAT (Shown)
Since the rear Spirit tires are
so soft for great traction, use
a few drops of SuperGlue
between the tire and wheel to
help keep the tires on.
STEP 36A
TOM CAT
Mount the rear wheels by
first inserting the axle pin
into the rear axle. Slide the
adapter onto the the axle
and onto the pin. Next install
the wheel onto the axle.
Push the wheel on until it fits
correctly on the adapter.
STEP 34
Press two (2) 5x11mm bush-
ings into each front wheel.
Spirit
STEP 36B
SPIRIT
You may have to turn the
wheel slightly in order to get
the proper alignment
between the wheel and the
adapter. Secure the wheel
with a 4mm lock nut.
STEP 35A
SPIRIT
Lubricate the front axle and
wheel bushings with 3-in-1
oil™. Mount the front wheels
by first sliding the spacer on
the axle, followed by a wheel,
a 5x10mm fiber washer, and
a 4mm lock nut. Do not over-
tighten.
Tom-Cat
STEP 37
Align the front end so that the
front wheels are pointing
straight or even 1 or 2
degrees inward (toed-in).
Make this adjustment by turn-
ing the ball end connector on
each of the front tie rods.
Snap the connectors onto the
balls of each of the steering
spindles to check the adjust-
ment.
9