Traxxas Spirit Operating Instructions Manual page 10

STEP 38A
SPIRIT
Position the front electrics
cover with the front body
mount as shown on the front
of the chassis. Use two (2)
3x30mm self-tapping screws
to attach the body mount and
secure the rear of the front
electronics cover. Complete
the installation with a
3x30mm round head screw,
a 3mm washer, and a 3mm
lock nut to secure the front of
the front electronics cover.
3x30mm
Roundhead
machine screw
STEP 41
Locate the plastic tube and
the antenna tip. Insert the
black antenna wire, extending
from the receiver housing, into
one end of the tube and push
it all the way through. Insert
the tube into the antenna
mount in the side of the
chassis. Fold the remaining
antenna wire over the top of
the antenna tube and secure
it with the vinyl antenna tip.
10
STEP 38B
TOM CAT
Position the front electrics
cover as shown on the front
of the chassis. Use two (2)
3x10 self-tapping screws to
secure the rear part of the
front electrics cover. Com-
plete the installation with a
3x30mm round head screw,
a 3mm washer, and a 3mm
lock nut to secure the front of
the front electronics cover.
3x30 Self-tapping
3x10mm Self-tapping
3mm Washer
3mm Locknut
STEP 42
Insert the nylon bands into
position for securing the
battery pack.
STEP 39
Assemble the drivers head
as shown using a 3x8mm
self-tapping screw. Mount
the assembled head to the
rear electrics cover with a
3x8mm self-tapping screw.
(See photograph in the next
step for the mounting loca-
tion.)
3x10mm
Self-tapping
STEP 43
Trim the body as shown.
Mount the TOM CAT wing to
the body with two (2) 3x8mm
washerhead screws, 3mm
washers, and 3mm locknuts.
(The wing for the SPIRIT is
molded into the body).
STEP 40
Attach the motor wires
(black-to-black and red-to-
red) and route them through
the channel in the side of the
chassis. As you position the
electronics cover, check the
blue and white wires that go
to the resistor pack to make
sure that they exit through
the channel at the top rear of
the cover. Secure the cover
with four (4) 3x10mm self-
tapping screws.
STEP 44
Mount the body using body
clips ("R" pins) to hold it in
place.