Table of Contents
Advertisement
STEP 17
Align the front suspension
assembly on the front of the
chassis and attach with two
(2) 3x15mm self-tapping
screws as shown.
2x8mm
3mm Washer
Self-tapping
2.6x10mm
Self-tapping
3x10mm
3x12mm
Self-
Shoulder screw
tapping
3mm Locknut
STEP 21
Attach servo mounts with
2.6x10mm self-tapping
screws and 3mm washers to
each servo as shown.
Notice that the mounts are
positioned differently on each
servo. Be sure that your ser-
vos match the photo and
drawings.
STEP 18
Position the front bumper on
the suspension assembly.
Now install the front bumper
stay plate and align. Secure
using four (4) 3x15mm self-
tapping screws with 3mm
washers.
2.6x14mm
Self-tapping
3x15mm
Self-tapping
STEP 22
Attach the servo saver & tie-
rod assembly to the steering
servo (Channel 1) as shown
with a 3x10mm self-tapping
screw.
STEP 19
77mm
97mm
Screw rod ends onto both
the long and short tie rods.
The overall length of the long
one should be about 97mm
and the short one should be
about 77mm. Connect both
rods to the servo saver with
a 3x12mm shoulder screw
and a 3mm lock nut as
shown (see drawing).
3x15mm
3mm Washer
Self-tapping
STEP 23
Mount the steering servo to
the chassis with two
2.6x14mm self-tapping
screws.
STEP 20
Connect your radio system
as described in your operat-
ing manual (not included with
kit) and center both servos.
3x10mm Self-
tapping (see
assembly
step 30)
STEP 24
Attach the servo horn to the
rotary speed control with
2x8mm self-tapping screws.
(In some kits it may already
be attached.) NOTE: The
servo horn provided will work
with TRAXXAS and FUTABA
radio systems. If you have a
different radio system, use a
servo horn which came with
your radio and looks like the
one in the photo.
7
Advertisement
Table of Contents
