PROGRAMMING THE ECHO
TO
THE SECURITY SYSTEM
The Echo must be programmed to the system in order to operate it. This programming procedure
is identical for a I-way transmitter or Echo transceiver. The original I-way transmitters may be used
to also operate the security system, in addition to the Echo. To program all, follow this procedure:
Have all of the transmitters or transceivers at hand (when one is programmed, all others are erased).
Step 1 Tum the vehicle's ignition "on".
Step 2 Within 5 seconds ofturning "on" the ignition, press the Valet Switch 5 times. The siren will
chirp once, confirming that the system is ready to learn an Echo or I-way transmitter.
Step 3 Within I0 seconds press and release the "ArmlLock" button (the "lockedpadlock" graphic).
The siren will chirp once, confirming that the system learned the Echo or transmitter.
Step 4 Repeat the previous step for each Echo or transmitter which is to operate the system.
•
The system will remove itself from the programming mode if
1
0 seconds expire without its
receiving a signal, if the ignition is turned "off', or upon four transmitters or transceivers
being programmed into the system.
•
Only the "Arm/Lock" button is pressed in programming; when it is learned all of the other
buttons' functions are automatically assigned.
Page -10
PROGRAMMING THE ECHO
TO
THE SECURITY SYSTEM
The Echo must be programmed to the system in order to operate it. This programming procedure
is identical for a I-way transmitter or Echo transceiver. The original I-way transmitters may be used
to also operate the security system, in addition to the Echo. To program all, follow this procedure:
Have all of the transmitters or transceivers at hand (when one is programmed, all others are erased).
Step 1 Tum the vehicle's ignition "on".
Step 2 Within 5 seconds ofturning "on" the ignition, press the Valet Switch 5 times. The siren will
chirp once, confirming that the system is ready to learn an Echo or I-way transmitter.
Step 3 Within I0 seconds press and release the "ArmlLock" button (the "lockedpadlock" graphic).
The siren will chirp once, confirming that the system learned the Echo or transmitter.
Step 4 Repeat the previous step for each Echo or transmitter which is to operate the system.
•
The system will remove itself from the programming mode if
1
0 seconds expire without its
receiving a signal, if the ignition is turned "off', or upon four transmitters or transceivers
being programmed into the system.
•
Only the "Arm/Lock" button is pressed in programming; when it is learned all of the other
buttons' functions are automatically assigned.
Page -10