System Board - HP Pavilion dv6500 Maintenance And Service Manual

3.
Disconnect the USB cable (3) and the power connector cable (4) from the USB/power connector
board.
4.
Remove the USB/power connector board.
Reverse this procedure to install the USB/power connector board.

System board

NOTE: All system board spare part kits include a modem cable and replacment thermal material.
Description
For use only with computer models equipped with discrete graphics subsystem memory (includes 128
MB of discrete graphics subsystem memory)
For use only with full-featured computer models equipped with UMA graphics subsystem memory
For use only with defeatured computer models equipped with UMA graphics subsystem memory
Before removing the system board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Switch cover (see
Battery on page 41).
Hard drive on page 46)
Optical drive on page
Switch cover on page
54)
56)
Component replacement procedures
Spare part number
446476-001
446477-001
453769-001
77