Starting The Engine - Polaris 600 IQ Widetrak Owner's Manual

OPERATION

Starting the Engine

1. Turn the key to the ON position.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never
engage the starter when the engine is running.
2. Pull the engine stop switch up to the RUN position.
3. Turn the key to START to crank the engine. Release the key to the
ON position when the engine starts. If using the starter rope, grasp
the starter handle and pull slowly until the recoil engages; then pull
abruptly to crank the engine.
TIP: Don't pull the starter rope to the fully extended position and don't allow it to
snap back into the housing. Damage may result.
4. If the engine does not start after several attempts, slightly depress
the throttle no more than 1/4 inch (6 mm) open while cranking the
engine. When the engine starts, immediately release the throttle.
CAUTION! To avoid injury and/or engine damage, do not operate the electric
starter or pull-rope starter while the engine is running.
NOTICE: Operating the vehicle immediately after cold starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle. If cold drive-away is attempted, the
engine RPM may stumble slightly to protect the engine.
66