Starting The Engine - Polaris General 1000 2023 Owner's Manual

OPERATING GUIDELINES
BOARDING AND EXITING THE VEHICLE
• Never try to climb onto or exit the vehicle while it is moving.
• Do not exit the vehicle by jumping off.
• Always face the vehicle when boarding or exiting.
• Do not grab controls as hand supports. This may cause inadvertent machine
movements.
• Always keep vehicle steps and flooring clean to prevent slippery conditions.

STARTING THE ENGINE

Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
1. Position the vehicle on a level surface outdoors or in a well- ventilated area.
2. Sit in the driver's seat and fasten the seat belt. Always make sure all cab
doors are closed and latched when riding in this vehicle.
3. Place the transmission in PARK.
4. Apply the brakes. Do not press the throttle pedal while starting the engine.
5. Turn the ignition key past the ON/RUN position and release immediately to
START. The engine will turn over for a maximum five seconds until the
vehicle has started.
6. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 5 and 6 until the
engine starts.
7. After starting the engine, wait 10 seconds before applying throttle.
8. Vary the engine RPM slightly with the throttle to aid in warm up until the
engine idles smoothly.
NOTICE
OPERATION
71