Using The Timer Play - Yamaha Disklavier E3 Operation Manual

Using the Timer Play

[SETUP] "TimerPlay"
You can program your Disklavier to start or stop playback of a song at
various specified times. All you need to do is register up to a maximum of
99 timer settings, and your Disklavier will perform them unattended. This
function is called "timer play."
The following describes how to play back the first album in the internal
flash memory at 8:15 AM.
1
Press [SETUP] on the remote control.
The setup menu screen appears.
=SETUP MENU=
*TimerPlay
*MIDI
2
Select "TimerPlay" with the cursor buttons ([
[ ]), then press [ENTER].
The timer play setting screen appears.
Program
number
3
Confirm that the cursor is on the timer switch, then press
[+/YES] and [–/NO] to switch the timer play on and off.
=TimerPlay=
>TimerPlay=ON
01[### ##:## ----
(1/3)
*AudioI/O
*M-Tune
(1/3)
=SETUP MENU=
*TimerPlay *AudioI/O
*MIDI *M-Tune
Timer switch
_? ]
=TimerPlay=
>TimerPlay=OFF
01[### ##:## ----
Day Time Function Album
selection
 -+
]
] [ ] [ ]
-+
]
Advanced Song Playback
Note:
The internal calendar must be set in
advance in order for the timer play
to function. See Chapter 2 "Getting
Started – Setting the Internal
Calendar" on page 11.
Note:
The control unit must be turned on
in advance in order for the timer
play to function. The timer play
cannot turn on/off the control unit.
Chapter
4
35