About This Manual - Fujitsu ETERNUS DX200F Operation Manual

Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX200F All Flash Array (herein-
after referred to as ETERNUS DX200F or ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes the operation management and maintenance of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.

About This Manual

Organization
This manual is composed of the following six chapters:
• "Chapter 1 Component Name/LED Name" (page 12)
This chapter provides component names of the ETERNUS DX.
"Chapter 2 Basic Operation" (page 19)
•
This chapter explains how to turn on and off the ETERNUS DX and how to operate the buttons on the oper-
ation panel.
"Chapter 3 Storage System Monitoring" (page 25)
•
This chapter describes the status monitoring of the ETERNUS DX.
"Chapter 4 Maintaining Optional Products " (page 29)
•
This chapter explains how to install drives and host ports in the ETERNUS DX and how to register the li-
cense.
"Chapter 5 Maintenance" (page 39)
•
This chapter describes maintenance once the ETERNUS DX starts to be operated.
"Chapter 6 Troubleshooting" (page 40)
•
This chapter explains troubleshooting when errors occur on the ETERNUS DX.
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
3
Preface
First Edition
May 2014
P3AM-8472-01ENZ0