ZyXEL Communications GS3700 Series User Manual page 150

Figure 95 Advanced Application > Port Authentication > 802.1x > Guest VLAN
The following table describes the labels in this screen.
Table 66 Advanced Application > Port Authentication > 802.1x > Guest VLAN
LABEL DESCRIPTION
Port This field displays a port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this checkbox to enable the guest VLAN feature on this port.
Clients that fail authentication are placed in the guest VLAN and can receive limited
services.
Guest Vlan A guest VLAN is a pre-configured VLAN on the Switch that allows non-authenticated users
to access limited network resources through the Switch. You must also enable IEEE 802.1x
authentication on the Switch and the associated ports. Enter the number that identifies the
guest VLAN.
Make sure this is a VLAN recognized in your network.
Host-mode Specify how the Switch authenticates users when more than one user connect to the port
(using a hub).
Select Multi-Host to authenticate only the first user that connects to this port. If the first
user enters the correct credential, any other users are allowed to access the port without
authentication. If the first user fails to enter the correct credential, they are all put in the
guest VLAN. Once the first user who did authentication logs out or disconnects from the
port, rest of the users are blocked until a user does the authentication process again.
Select Multi-Secure to authenticate each user that connects to this port.
Chapter 16 Port Authentication
GS3700/XGS3700 Series User's Guide
150