Table 3-1 At Jumper Options; Figure - Maxtor DiamondMax 17 80 ATA Installation And Use Manual

The configuration of the following three jumpers controls the drive's five modes of
operation:
– CS – Cable Select
– DS – Drive Select
– CLJ– Cylinder Limitation Jumper
The AT PCB has two jumper locations provided to configure the drive in a system.
The default configuration for the drive as shipped from the factory is with a jumper
across the CS location, and open positions in the DS and CLJ positions.
Table 3-1 defines the operation of the master/slave jumpers and their function
relative to pin 28 on the interface. 1 indicates that the specified jumper is installed;
0 indicates that the jumper is not installed.
CS DS Pin 28
0 0 X
1 0 Gnd
0 1 X
1 0 Open
1 1 X
Note: In Table 3-1, a 0 indicates that the jumper is removed, a 1 indi-
cates that the jumper is installed, and an X indicates that the
jumper setting does not matter.

Table 3-1 AT Jumper Options

Drive is configured as a slave.
Drive is configured as Master (Device 0) when attached to the end of a 80
conductor Ultra ATA cable.
Drive is configured as a Master.
Drive is configured as a Slave (Device 1) when attached to the middle of a 80
conductor Ultra ATA cable.
Drive is configured as a Master with an attached slave that does not support
Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive
DESCRIPTION
DASP.
Installation
3-5