Hardware Options; Configuration Jumpers And Connections; Jumper Options On The 68-Pin Wide Pcb - Maxtor ATLAS 15K II Product Manual

Installation
3.4

HARDWARE OPTIONS

3.4.1

Configuration Jumpers and Connections

This section includes setup and configuration information for Maxtor Atlas 15K II
drives. These disk drives include
• The 16-bit multimode Ultra320 SCSI, wide version with 68-pin SCSI
connector,
• The 16-bit multimode Ultra320 SCSI, version with SCA-2 80-pin
connector.
Specific individual settings for each drive type are described in Sections 3.5.1
through 3.5.4.
CAUTION: Before you begin, review the Safety, ESD, and Handling precau-
3.4.2

Jumper Options on the 68-Pin Wide PCB

This section describes how to configure the jumpers on Maxtor Atlas 15K II disks
with 68-pin SCSI interface connectors. The following features are jumper-
selectable:
• SCSI ID (0), (1),( 2), (3) – SCSI Bus Device Identification
• Delay Spin
• Single-Ended, Disable LVD
• Busy Out (Remote LED)
• Write Protect
• Stagger Spin
Note: The disk drive does not support on-board SCSI termination.
3-6 Maxtor Atlas 15K II
tions described at the beginning of this manual to avoid personal
injury or damage to equipment.