JVC KW·ADV792 Instructions Manual page 20

Volume Adjust
*1
Subwoofer Level
High Pass Filter
Crossover
Amplifier Gain
*2
Fader:
Adjust the front and rear speaker output balance.
• When using atwo-speaker system, set the fader level to "0."
• F6 to R6; Initial
~
Balance: Adjust the left and right speaker output balance.
• L6
to
R6;
Initial
~
Press [.. /~/~/~] to adjust.
Adjust and store the auto-adjustment volume level for each source, comparing
to the
FM
volume level. The volume level will automatically increase or decrease
when you change the source.
• <Fix>
appears if
"TUNER/Bluetooth PHONE"
is selected as the source.
• -12
to
+
12;
Initial
00
Adjust the subwoofer output level.
• -06 to +08; Initial 00
• Through : Select when the subwoofer is not connected.
• On : Select when the subwoofer is connected.
Select the crossover frequency between the front/rear speakers and the
subwoofer.
• 80Hz, 120Hz, 150Hz
You can change the maximum volume level of this unit.
• Off Deactivates the built-in amplifier.
• Low : VOL 00 to 30 (Select this if the maximum power of the
speakers is less than 50 W.)
• High :
VOL 00 to 50
*1
For "DISC/USB": You can make the adjustments separately depending on the audio format-Dolby digital, MPEG
Audio, and the others.
*2
The volume level automatically changes to "VOL 3D" ifyou change to <Low> with the volume level set higher than
"VOL 3D."
20