Verifying The Phone Startup Process - Cisco 7965G Administration Manual

Verifying the Phone Startup Process

Figure 3-3
1
2
3
Verifying the Phone Startup Process
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by
cycling through these steps.
1.
2.
Caution If the line keys flash red in sequence after flashing yellow, do not power down the phone until the
sequence of red flashes completes. This sequence can take several minutes to complete.
3.
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
3-12
Parts Used in Wall Mounting the Cisco Unified IP Phone
Footstand adjustment button—Raises and lowers adjustment plate
Wall mounting screw holes
Adjustment plate—Raises and lowers phone vertically
These buttons flash on and off in sequence:
Headset. (Only if the handset is off-hook when the phone powers up. Hang up the handset
–
within 3 seconds to have the phone launch its secondary load. To continue with the primary
load, leave the handset off-hook.)
– Mute.
Speaker.
–
Some or all of the line keys flash orange.
Some or all of the line keys flash green.
Normally, this sequence takes just a few seconds. However, if the phone flash memory is erased or
the phone load is corrupted, the sequence of green flashes will continue while the phone begins a
software update procedure. If the phone performs this procedure, the following buttons light to
indicate progress:
Headset—Phone is waiting for the network and completing CDP and DHCP configuration. (A
–
DHCP server must be available in your network.)
Chapter 3 Setting Up the Cisco Unified IP Phone
OL-12650-01