Mounting The Phone To The Wall - Cisco 7965G Administration Manual

Chapter 3 Setting Up the Cisco Unified IP Phone

Mounting the Phone to the Wall

You can mount the Cisco Unified IP Phone on the wall using the footstand as a mounting bracket or you
can use special brackets available in a Cisco Unified IP Phone wall mount kit. (Wall mount kits must be
ordered separately from the phones.) If you attach the phone to a wall using the standard footstand and
not the wall mount kit, you need to supply the following tools and parts:
•
•
See
Before You Begin
To ensure that the handset attaches securely to a wall-mounted phone, remove the handset wall hook
from the handset rest, rotate the hook 180 degrees, and reinsert the hook. Turning the hook exposes a lip
on which the handset catches when the phone is vertical. For an illustrated procedure, refer to Installing
the Wall Mount Kit for the Cisco Unified IP Phone.
To mount the phone on the wall using the standard footstand, follow these steps:
Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.
Caution
Procedure
Push in the footstand adjustment button.
Step 1
Step 2 Adjust the footstand so it is flat against the back of the phone.
Step 3 Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
Step 4
OL-12650-01
Screwdriver
Screws to secure the Cisco Unified IP phone to the wall
Figure 3-3 for a graphical representation of the phone parts.
Cisco Unified IP Phone 7965G and 7945G Administration Guide for Cisco Unified Communications Manager 6.0
Adjusting the Placement of the Cisco Unified IP Phone
3-11