Bosch WAY32540AU Instruction Manual And Installation Instructions page 39

Faults, what to do?
Faults
Water is running out.
Water not flowing in.
Detergent not
dispensed.
Washing machine
door cannot
be opened.
Programme does
not start.
Detergent solution is
not drained.
Water not visible in
the drum.
Spin result not
satisfactory.
Washing wet/too
damp.
Spin cycle activated
several times.
Residual water in the
dispenser for care
product.
Odour formation in
the washing
machine.
Loud noise
formation, vibrations
and "wandering"
during spin cycle.
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
– Start/Reload A
– Tap not open?
– Filter blocked? Clean the filter.
– Supply hose kinked or jammed?
– Safety function active. Stop programme?
– Rinse Hold (without final spin) selected?
$
– Can be opened via emergency release only? ~ Page 37
– Start/Reload A
– Door closed?
– Childlock active? Deactivate.
– Rinse Hold (without final spin) selected?
$
– Clean the drain pump. ~ Page 34
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
– Easy-Iron selected?
p
– Too low speed selected? ~ Page 23
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert. ~ Page 34
Run Cottons 90 °C programme without washing.
Use standard detergent.
– Appliance aligned?
Align the appliance. ~ Page 54
– Appliance feet fixed?
Secure appliance feet. ~ Page 54
– Transportation safety devices removed?
Remove transportation protection devices. ~ Page 48
not selected?
or Finished in time selected?
39