IBM THINKPAD R40 User Manual page 35

Note: Some models support Windows
v If the hibernation mode is not enabled. To enable it, do as follows:
For Windows 98:
1. Start the ThinkPad Configuration Program.
2. Click Power Management.
3. Click the Hibernation tab.
4. Click the Enable hibernation button.
5. Click the Create Now button.
For Windows NT:
Note: You must format your hard disk with the FAT format system to use
hibernation mode in Windows NT. If you format your hard disk with
NTFS, the default format in Windows NT, you cannot use hibernation
mode.
1. Start the ThinkPad Configuration Program.
2. Click Power Management.
3. Click Suspend/Resume Options.
4. Click Enable Hibernation.
5. Click OK.
®
For Windows XP or Windows
1. Start the ThinkPad Configuration Program.
2. Click Power Management.
3. Click the Hibernate tab.
4. Select the hibernate support checkbox.
5. Click OK.
Note: You can enter hibernation mode by pressing Fn+F12 only if the PM
driver for Windows
Problem: Under Windows
computer screen go blank.
®
Solution: Windows
same time. If you are the first user to have logged on to your computer, you
can use the Fn+F3 key combination. Otherwise the combination will not work
on your computer.
®
®
2000:
®
2000 or Windows
®
XP, the Fn+F3 key combination does not make the
XP enables multiple users to log on to the system at the
Solving computer problems
XP only.
®
XP has been installed.
Chapter 2. Solving computer problems
23