IBM Rack Power Distribution Unit Installation And Maintenance Manual page 15

7. Install the optional cable-management bracket beside the vertical-mounting plate
with four M6 screws and nuts that come with the Rack PDU.
8. If you installed a Universal Rack PDU, connect the power cord that comes with the
Rack PDU to the inlet on the Rack PDU. Repeat this step for all Universal Rack
PDUs.
9. Route the power cords from each Rack PDU toward the rack cabinet side braces;
then, route the power cords along a side brace towards the back of the rack
cabinet and secure the power cords with the cable straps that come with the Rack
PDU.
10. Route each power cord toward a dedicated power source. Use the provided cable
straps to secure power cords along the way. Use the openings in the rack cabinet,
if you must exit the rack cabinet to connect to a power source.
Chapter 2. Installing PDUs with the vertical-mounting plate
5