Table of Contents
Advertisement
2-9 CHANNEL 3 VALIDITY/LATCHED/LATCHED RESET WITH IGNITION/30
SECOND TIMED/SECOND UNLOCK OUTPUT: Channel 3 can be programmed for these
output configurations. The unit is set to the default validity output. To change the configuration,
use the two-chirp setting to toggle to the different configurations.
Transmitter/Receiver Learn Routine
NOTE: For information regarding transmitter programming please refer to the Owner's Guide.
The system comes with one transmitter that has been taught to it. The system can store up to four
different transmitter codes in memory. Use the following learn routine to add transmitters to the
system or to change button assignments if desired.
If the system was previously programmed using the 998T Bitwriter, the learn routine may be locked.
If the siren generates one long chirp when attempting to program the unit, the learn routine is locked
and must be unlocked using the 998T Bitwriter before proceeding.
1. O O p p e e n n a a d d o o o o r r . . (The GREEN wire, H1/5, or the VIOLET, H1/7 must be
connected.)
2. T T u u r r n n t t h h e e i i g g n n i i t t i i o o n n o o n n . . (The YELLOW wire, H1/9 must be connected.)
3. S S e e l l e e c c t t t t h h e e r r e e c c e e i i v v e e r r c c h h a a n n n n e e l l : : Press and release the Valet/Program button the
number of times necessary to access the desired channel.
NOTE: If adding a remote, a button must be taught to the unit in the Channel 1 or Channel 4
position prior to programming other channels.
Press and hold the Valet/Program button once more. The siren will chirp and the LED will blink
the number of times corresponding to the channel that is accessed.
©
2004
Directed Electronics, Inc.
21
Hide quick links:
Advertisement
Table of Contents
