Ccitt Commands - QMS 1725 SLS User Manual

Purpose Specifies the floating point number for point size.
Range
Default
Format
The CCITT command language consists of ASCII text strings that set
options for the CCITT emulation. The options must be set on a
per-image basis because they are returned to their default values
after each image is decompressed. If the correct options are not set
for decompression before the decompression begins, the emulation
absorbs the data until it finds a valid end-of-job marker.
The remainder of this chapter provides the function, syntax, and
default settings of all available CCITT commands.
To access CCITT emulation, include the following QMS Document
Option Commands (DOC) to the beginning of each data stream:
%%IncludeFeature:emulation(ccitt)
The following conventions are used in the discussion of all CCITT
commands that follow.
mixed-case bold
mixed-case italic
( )
0.25 to 999.75 in 0.25 increments
Printer configuration dependent
Floating point number
CCITT command
Command variable; replace thes variable with
information specific to your document
Introduce the command; you must type these
characters
Enclose command variables; you must type the
parentheses