e.
Palm rest (see
f.
Hard drive (see
g.
Display assembly (see
h.
Top cover (see
i.
System board (see
Remove the USB connector assembly:
1.
Position the computer right-side up with the right side toward you.
2.
Release the USB connector board cable from the base enclosure clips and routing channel (1).
3.
Remove the USB connector assembly (2) from the base enclosure.
Reverse this procedure to install the USB connector assembly.
106 Chapter 4 Removal and replacement procedures
Palm rest on page
72)
Hard drive on page
74)
Display assembly on page
Top cover on page
99)
System board on page
91)
103)