Cd Player; Using The System - Skoda Radio Blues Owner's Manual

CD player

Using the system

Information on how to use a CD
The internal drive can play CD-ROM, CD-R, CD-RW discs.
Insert the CD
With the labelled side facing up, only insert a CD into CD slot
matically drawn in.
The play function will start automatically.
Taking out the CD
Press the button – the CD is ejected.

If the "ejected" CD is not taken out within 10 seconds, it will be drawn in again for
safety reasons.
Buttons on the unit for controlling the current audio source
The arrow buttons or on the unit will always affect the audio source current-
 
ly being listened to, irrespective of the current menu used.
- brief pressing within 2 seconds of playback takes you to the beginning of the

previous track or chapter, or after 2 seconds to the beginning of the current title
or chapter.
- pressing this briefly changes over to the beginning of the next title or chap-

ter, repeated pressing changes over to the beginning of the subsequent title or
chapter.
Changing between the audio sources
Press the button to select the audio source: CD (internal CD drive), EXT (CD
MEDIA
changer, if it is connected to the device) or AUX.
6
CD player
WARNING
The CD-player is a laser product. On the manufacturing date, this unit was
classified as a class 1 laser product in accordance with the national/interna-
tional standards DIN EN 60825-1: 2008-05 and DHHS Rules 21 CFR,
Subchapter J classed as a class 1 laser product. The laser used in this class 1
laser product is so weak that there is no risk of danger when operated cor-
rectly. This product is designed such that the laser is restricted to the inside of
the unit. However, the installed laser could be classified in a higher class were
the housing to be removed. For this reason, never remove the housing of the
unit.
until it is auto-
10
CAUTION
Never insert CDs with the designation " into the internal drive. Do not insert in
■
drives without a drawer " or use Eco Discs.
After pressing the button
■
CD is ejected. During this time the lock in front of the CD-slot is open.
Be sure to wait until the CD has been fully ejected before you try to insert a new
■
CD. Otherwise you can damage the drive inside the unit.
A dirty, mechanically damaged, unreadable or incorrectly inserted CD can cause
■
playback problems. The CD may not be playable because of this or may cause it to
jump. Check the CD and insert it properly into the unit. Should problems persist ,
try using another CD and visit a specialist garage if necessary.
If the internal temperature of the device is too high, no CDs will be accepted.
■
The unit switches into the last active operating mode.
Never use liquids such as gasoline, paint thinner or record cleaner to clean the
■
surface of the CD - this may cause damage.
Never expose the CD to direct sunlight!
■
Only write on the CD using appropriate pens.
■
Do not stick anything to the CD.
■
Note
Poor or unsealed road surfaces and severe vibrations may cause the CD to jump.
■
In cold weather or after rain showers, moisture (condensate) may deposit in the
■
unit. This can effect the CD jump or impair the play function. In that case, wait un-
til the moisture has dissipated.
If a CD is dirty, never clean it in a circular motion, but instead work from the in-
■
side out. Use a soft, lint-free cloth. For heavy stains, we recommend that you
clean the CD with a commercially available CD cleaner and allow it to dry.
there is a time delay of a few seconds before the

