How Do I Input The Temperature And Altitude At Which The Striking Distance For Each Club Was Measured? (Gx-2I Only) - Leupold GX 1i Operating Instructions Manual

How do I Input tHe tempeRatuRe and altItude at wHIcH tHe StRIkInG
dIStance foR eacH club waS meaSuRed? (GX-2i only)
The procedure for inputting the temperature and
altitude at which each striking distance was measured
begins immediately after inputting the specific club dis-
tances . Follow each of the steps above under "How Do
I Activate the Club Selector?" and "How do I input the
striking distance of the 8, 6 and 4-iron?" Once the strik-
ing distances have been input, press MODe and follow
the steps below:
1) The last saved temperature will be flashing in the bottom portion of
the display . If you wish to input a temperature other than the one
shown, proceed to step 2 . To save the shown temperature, press MODe
and skip to step 3 below .
2) Press POWeR to begin incrementing through the temperature settings .
The default setting is 75 degrees F . Pressing POWeR will increment
through a range of 30 degrees to 120 degrees F in 5 degree increments .
When the appropriate temperature is displayed, press MODe to save
your selection and move on to the altitude input .
34
2
3
4
5
6
7
8
9
P