Remote Start Troubleshooting - Clifford Matrix RS2 Installation Manual

Matrix car security

Hide thumbs

Table Of Contents

Table of Contents

Closing the door triggers the system, but opening the door does not.

➤ ➤

Have you correctly identified the type of door switch system? This happens often when the

wrong door input has been used. (See Door Lock Harness Wire Connection Guide section of this

guide.)

System will not passively arm until it is remotely armed and then disarmed.

➤ ➤

Are the door inputs connected? Is the H1/6 blue wire connected to the door trigger wire in the

vehicle? Either the H1/5 green or the H1/7 violet should be used instead. (See wiring diagrams.)

Door input does not respond with the progressive trigger, but with immediate full alarm.

➤ ➤

Does the LED status indicator indicate that the trigger was caused by the shock sensor? (See Di-

agnostics section of this guide.) The shock sensor, if set to extreme sensitivity, may be detecting

the door unlatching before the door switch sends its signal. Reducing the sensitivity can solve

this problem.

The Valet/Program switch doesn't work.

➤ ➤

Is it plugged into the correct socket? See Plug-In Harnesses section of this guide.

LED status indicator doesn't work.

➤ ➤

You've probably guessed already, but here goes: Is it plugged in? (See Plug-In Harnesses section of

this guide.) Is the LED plugged into the correct socket?

Door locks operate backwards.

➤ ➤

This unit has easily-reversed lock/unlock outputs. Recheck wire connections to see if you have

reversed these.