Volvo S40 Owner's Manual page 100

2007 Volvo S40
To program (store) a seat position in memory button 1:
1. Adjust the seat to the desired position (see the instructions above).
96
04 Interior
Front seats
2. Press and hold down the "M" (Memory) button.
3. With the "M" button depressed, press memory button 1 to store the seat's current position.
To move the seat to the position that it was in when memory button 1 was programmed, press and hold down button 1
until the seat stops moving.
As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the preset
position.
Central locking system remote control and driver's seat memory
The remote control transmitter can also be equipped with an optional function that controls the electrically operated
driver's seat in the following way:
1. Adjust the seat to the desired position.
2. When you leave the car, lock it using the remote control.
3. The next time the driver's door is unlocked with the same remote control and that door is opened within 2 minutes, the
driver's seat and side door mirrors will automatically move to the position that they were in when the doors were most
recently locked with the same remote control.
NOTE
The memory function in the remote control operates independently of the memory function in the
seat.
WARNING
Because the driver's seat can be adjusted with the ignition off, children should never be left unattended in the car.
Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel.
Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be depressed fully. In
addition, position the seat as far rearward as comfort and control allow.
The seat rails on the floor must not be obstructed in any way when the seat is in motion.
97 04 Interior
file:///K|/ownersdocs/2007/2007_S40/07s40_04.htm (5 of 12)12/30/2006 5:44:42 PM