Transmitter/Receiver Learn Routine - Directed Electronics 100 ESP Installation Manual

transmitter/receiver learn routine

Transmitters are taught to the system using the Learn Routine. This system will learn up to four transmitters.
Both transmitters come factory programmed using Button I for lock, unlock, and panic; Button II for Channel 2
and Silent Mode; and Buttons I and II together operate Channel 3. This configuration can be changed or new
remotes can be added to the system using the Learn Routine. For added security, this Learn Routine can be locked
using the DEI Bitwriter (P/N 998T). If the unit does not respond to the Learn Routine, plug the Bitwriter into
the data port of this unit and verify that the Transmitter Programming is unlocked.
1. Key. Turn the ignition to the run position. (The YELLOW H1/9 wire must be already be con-
nected.)
2. Valet
times corresponding to the desired channel number. Then press the Valet/Program switch
once more and HOLD it. The LED will blink to indicate the selected channel and the horn
will honk (if connected). Do not release the Valet/Program switch.
CHANNEL PRESS AND RELEASE
NUMBER THE VALET/PROGRAM SWITCH
1 One time
2 Two times
3 Three times
4 Four times
5 Five times
6 Six times
7 Seven times
8 Eight times
9 Nine times
* NOTE: For Auto Learn Configurations, see Transmitter Configurations section of this guide.
NOTE: Channel Nine of the Transmitter Learn Routine will delete all transmitters that are pro-
grammed into the system as well as change the operating settings back to the default settings (see
Operating Settings Learn Routine section of this guide). To use this option, select Channel 9 (LED
will blink nine times) then transmit from any button of a known transmitter.
3. Transmit. While holding the
you would like to control the selected receiver channel. One honk will confirm that the code
has been learned.
4. Release. Once the code is learned, the Valet/Program switch can be released.
© 1999 Directed Electronics, Inc. Vista, CA
® /Program switch. Press and release the Valet
Valet
® /Program switch the correct number of
TO PROGRAM FUNCTION
Lock/Arm, Unlock/Disarm, Panic
Channel 2 output
Channel 3 output
Lock/Arm, Panic
Unlock/Disarm, Channel 2
Panic only
Auto Learn OEM Configuration*
Auto Learn Standard Configuration*
Delete all transmitters
® , press the button on the transmitter that
/Program switch
™
17