Connecting Your Monitor - IBM ThinkVision L190 User Manual

Connecting your monitor

Be sure to read the Safety
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
1. Turn off your computer and all attached devices. Next, unplug all power
cords to your computer and all attached devices.
2. Connect the signal cable.
• The analog signal cable is already connected to your monitor
(See in Figure A).
• When connecting the analog signal cable, connect the free end of the
attached signal cable to the 15-pin monitor port on the computer and
tighten the screws.
3. Connect the power cord to the monitor and then plug the power cord into
a properly grounded outlet. Next, reconnect the power cords to your
computer and all attached devices.
Figure A
9