Auto Focus; Motion Det - Samsung SCC-C4201(P) User Manual

CTRL TYPE : You can select the A, B, C, or D mode
depending on the input of the wired remote control terminal.
(See page 7.)
RS-485 : Set the address and baud rate for RS-485
communication.
Caution : A communication error may occur if you connect
more than one camera set with an identical
address.
PIP : This is the Picture in Picture feature. It will show a
screen reduced by 1/16 of the main screen only when
operating the Digital Zoom. If you set the PIP option to ON
and press the ENTER button, you can use the UP, DOWN,
LEFT, and RIGHT buttons to set the PIP position.
* The PIP feature does not work in a low speed shutter mode.
The MIRROR feature does not work on the PIP window.
(SPECIAL)
V-SYNC LINE...
CTRL TYPE A
RS-485 ...
PIP ON
MIRROR OFF
Press the
D-ZOOM OFF
ENTER
POSI/NEGA +
ZOOM SPEED 3
button.
DETAIL (0) ----I--
RET
MIRROR : Horizontally flips the video output signal.
D-ZOOM : Sets the magnification of the Digital Zoom.
The magnification level can be set to up to 10x.
POSI/ NEGA : Outputs the video output signal normally or
inversely.
ZOOM SPEED : In the ZOOM SPEED option, use the
LEFT and RIGHT buttons to set the speed as follows:
1 : Takes about 17 seconds from 1 x to 22 x magnification (slowest speed).
2 : Takes about 10 seconds from 1 x to 22 x magnification (slow speed).
3 : Takes about 6 seconds from 1 x to 22 x magnification (fast speed).
4 : Takes about 3 seconds from 1 x to 22 x magnification (fastest speed).
DETAIL: Adjusts the sharpness.
23

AUTO FOCUS

In the AUTO FOCUS option, you can specify the Focus
method to AF, MF, or ONEAF.
AF : Focuses automatically by continuously monitoring the
screen in AUTO FOCUS mode. It does not process the
FOCUS button input because it focuses automatically
during ZOOM.
MF : You can manually adjust the focus.
ONEAF : Focuses about 5 seconds only when ZOOM is
moved Wide to Tele. It is same as MF mode while in STOP
mode, and same as AF mode after ZOOM Tele.
PIP

MOTION DET

In the MOTION DET option, you can set the Motion
Detection function, motion detection sensitivity, and the
motion detection area. If you set the Motion Detection
function, you can detect an intruder's movement and check it
through the monitor and the ALARM OUT terminal.
(SET UP)
CAMERA ID
IRIS
SHUTTER
AGC
WHITE BAL
SPECIAL
AUTO FOCUS
MOTION DET
PRESET
COLOR/BW
EXIT
(SET UP)
CAMERA ID OFF
IRIS ALC...
SHUTTER OFF
AGC LOW
WHITE BAL ATW
SPECIAL ...
AUTO FOCUS AF
MOTION DET OFF
PRESET ...
COLOR/BW COLOR
EXIT QUIT
(MOTION DET)
OFF
ALC...
OFF
LOW
ATW
...
Press the
ONEAF
ENTER
ON...
... AREA
button.
COLOR SENSITIVITY
QUIT RET
PRESET...
MEDIUM
24