Table of Contents
Advertisement
T50_setup.fm Page 9 Thursday, August 9, 2001 11:09 AM
Auto Setup for DOS
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
If this happens, switch off the
monitor and switch it on again
after a few seconds.
If you are using PC-DOS
IV, change to U.S. mode
by typing 'CHEV US' and
pressing ENTER at the
command prompt.
You must use DOS when
you run DOS Auto Setup.
The size and diversity of
the dot pattern varies with
the screen resolution.
If the screen flickers,
repeat the setup several
times until the flicker is
minimised, or adjust it manually
by following Manual setup.
1.
Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
•
that the video interface cable is connected properly.
•
the correct video adapter card is installed.
•
the correct supported display mode is selected for your PC.
2.
Wait approximately 15 minutes, until the monitor warms up.
3.
Insert the diskette labelled 'IBM Flat Panel Monitor Installation Diskette
into the diskette drive.
4.
Display the command prompt screen of the DOS full-screen display.
5.
At the command prompt, type 'A:' and press ENTER.
6.
Type 'TESTPATD' and press ENTER.
7.
Select from the screen the number for the color or text mode you want to
setup.
8.
Select from the screen the number for the video mode you want to
setup.
You may repeat this process for as many of the color and video modes
as you need.
9.
When the dot pattern appears, press the OSD Enter button
bottom of the monitor to display the initial OSD menu.
- , +
10. Use buttons (
) to select the IMAGE LOCK icon
OSD Menu
button to access the function.
- , +
11. Using buttons (
), select
button
. This activates the
the display settings with the provided dot-patterns.
The screen will be off several times and you may notice small changes
to the test pattern.
12. When finished, the OSD main menu returns. Press the Exit button to exit
from the OSD.
13. Press the ESCAPE key to exit the test pattern program.
14. Type 'Exit' at the command prompt to return to Windows.
If you use other operating systems, perform the appropriate
those systems, also: see
Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT or
Windows 2000.
and press the OSD Menu
AUTOMATIC
procedure, which will optimize
A
S
UTO
ETUP
A
at the
then press the
for
S
UTO
ETUP
9
Advertisement
Table of Contents
