Changing The Display; In Case Of Difficulty; Basic; Radio - Alpine CDE-177BT Owner's Manual

Notes
• If no operation is performed for 60 seconds, the search mode is
cancelled.
• In the search mode, pressing t will return to the previous search
hierarchy.
• Depending on the vTuner application, search category, search hierarchy,
etc., may differ.
• During search mode, pressing VIEW may change the display.
• In some cases, certain search mode may not work, or some stations
cannot play normally.
• The provided stations are subject to change, please visit the home page
of vTuner for the latest information.

Changing the Display

Press VIEW.
STATION NAME/GENRE NAME  STATION NAME/LANGUAGE 
CLOCK  STATION NAME/GENRE NAME
Note
• Some characters may not be correctly displayed.
42
-EN
Information

In Case of Difficulty

If you encounter a problem, please turn the power off, then on again. If
the unit is still not functioning normally, please review the items in the
following checklist. This guide will help you isolate the problem if the
unit is at fault. Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.

Basic

No function or display.
• Vehicle's ignition is off.
– If connected following instructions, the unit will not operate with
the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow) connections.
– Check power lead and battery lead connections.
• Blown fuse.
– Check the fuse of the unit; replace with the proper value if
necessary.
• Internal micro-computer malfunctioned due to interference noise
etc.
– Press the RESET switch with a ballpoint pen or other pointed
article.

Radio

Unable to receive stations.
• No antenna or open connection in cable.
– Make sure the antenna is properly connected;
replace the antenna or cable if necessary.
Unable to tune stations in the seek mode.
• You are in a weak signal area.
– Make sure the tuner is in the DX mode.
• If the area you are in is a primary signal area, the antenna may not be
grounded and connected properly.
– Check your antenna connections; make sure the antenna is
properly grounded at its mounting location.
• The antenna may not be the proper length.
– Make sure the antenna is fully extended; if broken, replace the
antenna with a new one.
Broadcast is noisy.
• The antenna is not the proper length.
– Extend the antenna fully; replace it if it is broken.
• The antenna is poorly grounded.
– Make sure the antenna is grounded properly at its mounting
location.
CD
CD Player not functioning.
• Out of operating temperature range +50°C (+120°F) for CD.
– Allow the vehicle's interior (or trunk) temperature to cool.
CD playback sound is wavering.
• Moisture condensation in the CD Module.
– Allow enough time for the condensation to evaporate (about
1 hour).
CD insertion not possible.
• A CD is already in the CD player.
– Eject the CD and remove it.