Eco Operation; Precautions For Safety; Remote Control; Indoor Unit Display - Toshiba RAS-107 Owner's Manual

PRECAUTIONS FOR SAFETY

• Do not install, repair, open or remove the cover. It may expose you
to dangerous voltages. Ask the dealer or the specialist to do this.
• Turning off the power supply will not prevent potential electric
shock.
• The appliance shall be installed in accordance with national wiring
DANGER
regulation.
• Means for disconnection from the supply having a contact
separation of at least 3 mm in all poles must be incorporated in the
fi xed wiring.
• Do not expose your body directly to cool air for a long time.
• Do not insert your fi nger or any article into the air inlet/outlet.
• When an abnormality (burning smell, etc.) occurs, stop the air
conditioner and disconnect the power supply or turn off the
breaker.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
WARNING
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with
the appliance.
• Do not wash the unit with water. It may cause an electric shock.
• Do not use this air conditioner for other purposes such as
preserving food, breeding animal, etc.
• Do not step or put anything on the indoor/outdoor unit. It may
cause an injury or damage the unit.
• Do not touch aluminium fi n because it may cause an injury.
• Before cleaning the unit, turn off the main switch or the circuit
CAUTION
breaker.
• When the unit won't be used for a long time, turn off the main
switch or the circuit breaker.
• It is recommended that maintenance be performed by a specialist
when the unit has been operated for a long time.
1

INDOOR UNIT DISPLAY

Models: RAS-137, 167SKV Series
Hi POWER FILTER PRE. DEF TIMER
Models: RAS-107SKV Series
CLEANING
RESET TIMER OPERATION
2

PREPARATION BEFORE USE

Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type) following the (+)
and (–) positions.
Clock Setup
1. Push CLOCK by tip of the pencil.
●
2. Press or
ON
3. Press : Set the time.
SET
Remote Control Reset
1. Remove the battery.
2. Press .
3. Insert the battery.
3

AIRFLOW DIRECTION

FIX
1
Press : Move the louver in
the desired vertical direction.
SWING
2 Press : Swing the air
automatically and press again to
stop.
For horizontal direction, adjust
3
manually.
Note:
• Do not move the louver manually by others.
• The louver may automation positioning by come operation mode.
1110250170_EN.indd 2 1110250170_EN.indd 2
1 Hi POWER (Green)
2 FILTER (Orange)
OPERATION
3 PRE. DEF (DE-FROST) (Orange)
4 TIMER (Yellow)
5 OPERATION (Green)
RESET
6 RESET button
1 OPERATION (Green)
2 TIMER/CLEANING (Yellow)
3 RESET button
: adjust the time.
OFF
4

REMOTE CONTROL

1 Infrared signal emitter
2 Start/Stop button
3 Mode select button (MODE)
4 Temperature button (TEMP)
5 Fan speed button (FAN)
6 Swing louver button (SWING)
7 Set louver button (FIX)
8 On timer button (ON)
9 Off timer button (OFF)
! Sleep timer button (SLEEP)
" Setup button (SET)
# Clear button (CLR)
$ Memory and Preset button (PRESET)
% One Touch button (ONE-TOUCH)
& High power button (Hi-POWER)
( Economy button (ECO)
) Quiet button (QUIET)
~ Comfort sleep button (COMFORT SLEEP)
+ Filter reset button (FILTER)
, Clock Reset button (CLOCK)
- Check button (CHK)
5
ONE-TOUCH
Press the "ONE-TOUCH" button for fully automated operation that is
customised to the typical consumer preferences in your region of the world.
The customised settings control temperature air fl ow strength, air fl ow
direction and other settings to provide you alternate contact with "ONE-
TOUCH" of the button. If you prefer other settings you can select from the
many other operating functions of your Toshiba unit.
ONE-TOUCH
Press : Start the operation.
6

AUTOMATIC OPERATION

To automatically select cooling, heating, or fan only operation
MODE
1. Press : Select A.
TEMP
2. Press : Set the desired temperature.
COOLING / HEATING / FAN ONLY
7
OPERATION
MODE
1. Press : Select Cool , Heat
TEMP
2. Press : Set the desired temperature.
Cooling: Min. 17°C, Heating: Max. 30°C, Fan Only:
No temperature indication
FAN
3. Press : Select AUTO, LOW , LOW+
MED+ , or HIGH .
8

DRY OPERATION

For dehumidifi cation, a moderate cooling performance is controlled
automatically.
MODE
1. Press : Select Dry .
TEMP
2. Press : Set the desired temperature.
9
Hi-POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling or
heating operation (except in DRY and FAN ONLY mode)
Hi-POWER
Press : Start and stop the operation.
10

ECO OPERATION

To automatically control room to save energy (except in DRY and FAN ONLY
mode)
ECO
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1
degree/hour for 2 hours (maximum 2 degrees increase). For heating
operation the set temperature will decrease.
, or Fan only .
, MED ,
12/23/09 3:46:29 PM 12/23/09 3:46:29 PM