Remove The Grille To Install The Indoor Unit - Sanyo SAP-KRV94EHDX Technical & Service Manual

7-5. Remove the Grille to Install the
Indoor Unit
Basically, these models can be installed and wired
without removing the grille. If access to any internal
part is needed, follow the steps as given below.
How to remove the grille
(1) Open the front panel until it is nearly horizontal,
grasp the sections near the front panel arms on
both sides, and then pull forward to remove the
front panel. (Fig. 9)
(2) Remove the screw from the top right of the main
unit. Also remove the screws where the screw
covers are open. (Fig. 10)
(3) Press the 3 tabs on the top of the grille to
disengage them. (Fig. 10)
(4) Pull the grille toward you to remove it. (Fig. 10)
How to replace the grille
(1) Insert the bottom of the grille into the flap, with the
flap at a more-or-less horizontal position.
(2) While aligning both edges of the grille with the
frame, move the panel horizontally and insert the
top and bottom into the frame.
(3) Press the air outlet firmly with your hand to ensure
no gap exists between the main unit and grille.
(4) Tighten the screws and close the screw covers.
(5) Grasp the sections near the front panel arms on
both sides, hold the front panel so that it is nearly
horizontal, bring the arm shafts into contact with
the top of the grooves on the right and left sides of
the air conditioner, and then push firmly until the
arm shafts click into place. (Fig. 11)
(6) After closing the front panel, press firmly on the
parts indicated by the arrows to securely fasten the
panel in place. (Fig. 12)
NOTE
Check that no gap exists between the main unit and
grille.
Front panel
Arm
Grille
Screw
Front panel
27
Fig. 9
Screw
Flap
Screw cover
Fig. 10
Groove
Pin
Arm
Fig. 11
Fig. 12