Smoke Sensor Reset; Zone Name; Walk Test All Zones; Walk Test A Single Zone - Bosch Solution 64 User Manual

Inputs > Commands >

Smoke Sensor Reset

This menu allows you to reset smoke sensors.
1. Enter [MENU] + [3] + [0] + [5].
A list of different areas will display on the keypad.
2. Use the [ ] and [ ] keys to select the area that you want
to reset the smoke detectors, then press [OK] to select.
Alternatively, you can enter the area number, then press
[OK].
The keypad will display the following:
Smoke detector reset in
Progress. Please wait
3. The keypad will automatically return to the menu when all
smoke detectors in the area has been reset.
Inputs > Zone Properties >

Zone Name

This menu allows you to program up to 16 characters for the
name of each zone.
1. Enter [MENU] + [3] + [1] + [0].
A list of different zones will display on the keypad.
2. Use the [ ] and [ ] keys to select the zone name that you
want to change, then press [OK] to select. Alternatively, you
can enter the zone number, then press [OK].
The keypad will display the following:
Zone Name Z001
Zone 1 Name
Press
3. Use the [ ] and [ ] keys to scroll the cursor left and right
across the zone name text. Use the [ ] and [ ] keys to scroll
through the different characters available. To clear all text
from the cursor position to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Inputs > Input Testing >

Walk Test All Zones

This menu allows you to test all zones within an area at the same
time. To successfully walk test each zone, you must open and
close each zone.
1. Press [MENU] + [3] + [9] + [0].
The keypad will display a list of areas that are available to
walk test zones.
2. Use the [ ] and [ ] keys to select the area that you want to
do walk test, then press [OK] to select. Alternatively, you
can enter the area number, then press [OK].
Bosch Security Systems | 12/05 | BLCC110U
MENU 3-0-5
MENU 3-1-0
OK to SAVE
MENU 3-9-0
The keypad will scroll all zones that you can test.
To test Z001 open/close
Zone 1
Press OK or MENU
To test Z002 open/close
Zone 2
Press OK or MENU
3. Open and close each zone that needs to be tested. A zone
that has been successfully tested will no longer scroll on the
keypad display.
When all zones have been tested, the keypad will display:
Selected zones have been
Tested OK
Press OK or MENU
4. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Inputs > Input Testing >

Walk Test A Single Zone

This menu allows you to select a single zone to be tested via walk
test.
1. Press [MENU] + [3] + [9] + [1].
The keypad will display a list of zones that are available to be
tested via walk test.
2. Use the [ ] and [ ] keys to select the zone that you want to
walk test, then press [OK] to select. Alternatively, you can
enter the zone number, then press [OK].
The keypad will display the zone to be tested.
To test Z001 open/close
Zone 1 Name
Press OK or MENUMENU
3. Open and close the zone that needs to be tested.
When the zone has been successfully faulted and restored,
the keypad will display:
Z001 Zone 1 Name
Test Successful
Press OK or MENUMENU
4. Press [OK] to save and exit, or press [MENU] to exit without
saving.
Solution 64 | User Guide
MENU 3-9-1
17