Table of Contents
Advertisement
vmfview install
A.1.3 Process Additional Service
40
Tivoli ADSM for VM Program Directory
2
Check the receive message log ($VMFREC $MSGLOG) for warning and error
messages. If necessary, correct any problems before going on. For
information about handling specific receive messages, see VM/ESA: System
Messages and Codes, or use online HELP.
1
Apply additional service
The VMFAPPLY command is used to reapply service that was not contained
on the refresh tape that was already installed for the component.
Applying service with preapplied, prebuilt service will reapply any reach-ahead
service that may be on the system or indicate that there are no reach-ahead
PTFs to be applied.
yynn
Advertisement
Table of Contents
