Table of Contents
Advertisement
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn burner on and off
with hand-held remote control unit.
IMPORTANT: Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain battery.
Flame
Adjustment Knob
Control Knob
Remote Selector Switch in
in On Position
Remote Position (Optional
Hand-Held Remote Control)
Figure 33 - Setting the Remote Selector
Switch, Control Knob and Flame
Adjustment Knob for Remote Operation
ON/OFF SERIES (MODEL HC100)
Hold the control button on hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 34).
To Lock press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If fire is on
it will be turned off automatically. In the locked
state, light will not light up when any button
is pressed.
To Unlock press both buttons together on
hand-held remote control until light stops
flashing. The hand-held remote is now un-
locked.
Indicator
Light
Figure 34 - On/Off Hand-Held Remote
Control Unit (HRC100)
113195-01J
OpERATiON
Continued
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated using
either manual mode (MANU) or thermostatic
mode (AUTO) (see Figure 35). To select Fahr-
enheit/Centigrade mode display, carefully
press ˚C/˚F mode button with the end of a
paper clip or similar blunt object.
Manual Mode
1. Press POWER and LOCK buttons togeth-
2. Press MANU button to turn on fireplace.
3. Press POWER and LOCK buttons to-
Auto (Thermostatic) Mode
1. Press POWER and LOCK buttons togeth-
2. Press AUTO button to select this mode.
3. Set desired room temperature by pressing
4. Press POWER and LOCK buttons to-
Note: Do not leave hand-held remote in the
AUTO mode close to fireplace. The radiant
heat from fireplace will turn off fireplace. Ide-
ally, place hand-held remote in the center of
the room facing towards fireplace.
Note: Do not hold hand-held remote for a long
time. Body temperature will affect its operation
in AUTO mode.
Control Button
Turns Burners
On and Off
www.desatech.com
er to turn on hand-held remote control.
gether to turn off fireplace.
er to turn on hand-held remote control.
TEMP + or - buttons.
gether to turn off fireplace
Digital Display Shows
Temperature and Settings
Locks
System to
ROOM
TEMP
Prevent
Accidental
LOCK
Ignition
MANU
Turns
Burners
On or Off
Increases and Decreases
Room Temperature in
AUTO Mode
Figure 35 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Turns
Hand-Held
Remote On
AUTO
SET
or Off and
TEMP
Allows You
TEMP
POWER
to Choose
the Manual
AUTO
Setting
ºC/ºF
Selects Auto
Setting
21
Advertisement
Table of Contents
