Periodic Inspection - Toshiba MMY-MAP0804HT8 Owner's Manual

Multi type
Hide thumbs Also See for MMY-MAP0804HT8:
Table of Contents

Advertisement

SMMS-i
◆ Floor standing cabinet type
1
Push down the upper part of the return air
grille slightly, and then pull it toward you to
remove it.
2
Take out the air filter inside the return air
grille.
3
Vacuum dust or brush clean.
• If heavily stained, it is more effective to wash in
lukewarm water mixed with neutral detergent.
• After washing, rinse it well, and dry it in the
shade.
• Reinstall the cleaned air filter.
◆ Floor Standing Concealed Type
1
Push down hook of the air filter on the front
panel (Lower side).
2
Pull the air filter toward you to remove it.
Front panel
(Lower)
Air filter knob
35-EN
Owner's Manual
3
Vacuum dust or brush clean.
• If heavily stained, it is more effective to wash in
lukewarm water mixed with neutral detergent.
• After washing, rinse it well, and dry it in the
shade.
• Reinstall the cleaned air filter.
◆ Floor standing type
1
Remove the air filter.
• Pull down the air filter toward you.
• To attach the air filter, insert it into the unit and
push it in.
2
Vacuum dust or brush with water.
• If heavily stained, it is more effective to wash in
lukewarm water mixed with neutral detergent.
• After washing, rinse it well, and dry it in the
shade.
3
Vacuum dust or brush clean.
• If heavily stained, it is more effective to wash in
lukewarm water mixed with neutral detergent.
• After washing, rinse it well, and dry it in the
shade.
• Reinstall the cleaned air filter.
SMMS-i
Cleaning the indoor unit and
remote controller
• Ask qualified service person to clean the indoor units
for the models listed in the warning on the top of this
chapter.
• Wipe with a dry, soft cloth.
• If heavily stained, wipe off dirt with a cloth soaked in
lukewarm water.
(Do not use water to wipe the remote controller)
• Do not use benzine, thinner, scouring powder,
chemical cloth, etc. as those may cause deformation
or breakage.
If unused for over a month
• Leave the fan on for half a day or so to dry the inside.
• Turn off the main power switch.
• Clean the air filter and then attach it.

Periodic inspection

• After being used for a long period of time, the parts
may deteriorate or malfunction, or the drainage may
worsen, due to heat, moisture, dust, or general
usage.
• In addition to the maintenance, it is recommended
that you have a inspection (charges apply)
performed by the dealer where you purchased the
unit, etc.
CAUTION
4-way air discharge cassette type
• Perform high-pressure cleaning for the heat
exchanger.
If commercially available detergent (strong alkaline
or acid cleaning agent) is used, the surface
treatment of the heat exchanger will deteriorate,
which may degrade the self cleaning performance.
For details, contact our sales department or the
dealer where you purchased the unit.
– 18 –
Owner's Manual
Before the cooling season
Ask a qualified service person to clean the drain
pan
CAUTION
Clean the drain pan
Without cleaning, the drain pan may be filled with
waste, and water may overflow onto the ceiling or floor.
If you do not plan to use the unit for more
than 1 month
(1) Operate "FAN" mode.
Run the fan for about half a
day to dry the inside fully.
(2) Stop the air conditioner and
turn off the main power
switch.
Checks before operation
(1) Check that the air filters are installed.
(2) Check that the air outlet or inlet is not blocked.
(3) Turn on the main power switch.
EN
36-EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mmy-map1604ht8Mmy-map1004ht8Mmy-map0804ht8zMmy-map1004ht8zMmy-ap1204ht8zMmy-map1404ht8z ... Show all

Table of Contents